Chapter 7 Interfaces
USG FLEX H Series User’s Guide
133
7.7.1 Configuring a User-Defined Trunk
Click Network > Interface > Trunk, in the User-Defined Trunk table click the Add (or Edit) icon to open the
following screen. Use this screen to create or edit a WAN trunk entry.
Figure 97 Network > Interface > Trunk > User-Defined Trunk > Add (or Edit)
Each field is described in the table below.
Table 70 Configuration > Network > Interface > Trunk > Add (or Edit)
LABEL DESCRIPTION
Name This is read-only if you are editing an existing trunk. When adding a new trunk, enter a
descriptive name for this trunk. You may use 1-31 alphanumeric characters, underscores
(
_), or dashes (-), but the first character cannot be a number. This value is case-sensitive.
Load Balancing
Algorithm
Select a load balancing method to use from the drop-down list box.
Select Weighted Round Robin to balance the traffic load between interfaces based on
their respective weights. An interface with a larger weight gets more chances to transmit
traffic than an interface with a smaller weight. For example, if the weight ratio of wan1 and
wan2 interfaces is 2:1, the Zyxel Device chooses wan1 for 2 sessions’ traffic and wan2 for 1
session’s traffic in each round of 3 new sessions.
Add Click this to create a WAN trunk entry.
Edit Select an entry and click Edit to modify the entry’s settings.
Remove To remove a member interface, select it and click Remove. The Zyxel Device confirms you
want to remove it before doing so.
Name Select an interface name from the drop-down list box.
To Next Page
Loading...
