ZyXEL Communications USG FLEX H Series - 5.14 The Device Insight Screen

Chapter 5 Monitor
USG FLEX H Series User’s Guide
84
5.14 The Device Insight Screen
Use Device Insight to collect status and basic information of the clients connected to the Zyxel Device
internal interfaces or IPSec VPN. The clients shown may include clients connected to the Zyxel Device:
• Using wired connections.
• Through access points (APs) using wired connections.
• Through access points (APs) using WiFi connections.
• Through built-in access points using WiFi connections.
• Using SecuExtender (IPSec VPN clients).
Device Insight collects client information including:
• Hostname
• IP address and MAC address
• Operating system
• Category, such as mobile phones or computers
• Connected interface
Note: To collect clients’ information using Device Insight, the clients must be in the same IP
subnet in the LAN/VLAN/DMZ networks behind the Zyxel Device. Information from
clients that are in different IP subnets in the LAN/VLAN/DMZ networks might not be
collected correctly as traffic must pass through another router or a layer-3 switch to the
Zyxel Device.
Destination
Country
This field displays when View is set to all sessions. Select the country where the traffic is going to.
# This field is the rank of each record. The names are sorted by the name of user in active session.
You can use the pull down menu on the right to choose sorting method.
User This field displays the user in each active session.
If you are looking at the sessions by users (or all sessions) report, click + or - to display or hide
details about a user’s sessions.
Services This field displays the protocol used in each active session.
If you are looking at the sessions by services report, click + or - to display or hide details about
a protocol’s sessions.
Source This field displays the source IP address and port in each active session.
If you are looking at the sessions by source IP report, click + or - to display or hide details about
a source IP address’s sessions.
Destination This field displays the destination IP address and port in each active session.
If you are looking at the sessions by destination IP report, click + or - to display or hide details
about a destination IP address’s sessions.
Rx This field displays the amount of information received by the source in the active session.
Tx This field displays the amount of information transmitted by the source in the active session.
Duration This field displays the length of the active session in seconds.
Table 44 Network Status > Session Monitor (continued)
LABEL DESCRIPTION