Chapter 7 Interfaces
USG FLEX H Series User’s Guide
123
A bridge interface may consist of the following members:
• Zero or one VLAN interfaces (and any associated virtual VLAN interfaces)
• Any number of Ethernet interfaces (and any associated virtual Ethernet interfaces)
When you create a bridge interface, the Zyxel Device removes the members’ entries from the routing
table and adds the bridge interface’s entries to the routing table. For example, this table shows the
routing table before and after you create bridge interface br0 (250.250.250.0/23) between lan1 and
vlan1.
In this example, virtual Ethernet interface lan1:1 is also removed from the routing table when lan1 is
added to br0. Virtual interfaces are automatically added to or remove from a bridge interface when
the underlying interface is added or removed.
7.4.1 Bridge Add/Edit
This screen lets you configure IP address assignment, interface bandwidth parameters, DHCP settings,
and connectivity check for each bridge interface. To access this screen, click Network > Interface >
Interface > Bridge > Add/Edit. The following screen appears.
Table 66 Example: Routing Table Before and After Bridge Interface br0 Is Created
IP ADDRESS(ES) DESTINATION IP ADDRESS(ES) DESTINATION
210.210.210.0/24 lan1 221.221.221.0/24 vlan0
210.211.1.0/24 lan1:1 230.230.230.192/26 wan2
221.221.221.0/24 vlan0 241.241.241.241/32 dmz
222.222.222.0/24 vlan1 242.242.242.242/32 dmz
230.230.230.192/26 wan2 250.250.250.0/23 br0
241.241.241.241/32 dmz
242.242.242.242/32 dmz
To Next Page
Loading...
