ZyXEL Communications USG FLEX H Series - Exit the Wizard

Chapter 2 Initial Setup Wizard
USG FLEX H Series User’s Guide
39
Figure 23 Register Device
Click Refresh or use the Licensing > Licenses screen after you log into the web configurator to update
your Zyxel Device registration status.
The Registration Status field may display Registered or Not registered.
• Registered: Your Zyxel Device has successfully registered at NCC.
• Not registered: Your Zyxel Device is not registered at NCC. Make sure you’re connected to the
Internet. Wait a few minutes then click Refresh to update the registration status.
2.5.1 Exit the Wizard
The Exit button displays if the Zyxel Device is not connected to the Internet when you are at the Device
Registration step. You will be redirected to the Zyxel Device login page after you click Exit.
You cannot use the Zyxel Device security services and upgrade firmware if you do not register your Zyxel
Device at NCC.