Chapter 25 Log and Report
USG FLEX H Series User’s Guide
394
25.3 Log Settings Screen
The Log Settings screen control log messages. A log message stores the information for viewing or
regular emailing later.
The Zyxel Device provides a system log and supports email profiles and remote syslog servers. Use the
email profiles to mail log messages to the specific destinations. You can also have the Zyxel Device store
system logs on a connected USB storage device. The other two logs are stored on specified syslog
servers.
Note: Only connect one USB device. It must allow writing (it cannot be read-only) and use the
FAT16, FAT32, EXT2, or EXT3 file system.
To access this screen, click Log & Report > Log Settings.
Message This field displays the reason the log message was generated. The text “[count=x]”,
where x is a number, appears at the end of the Message field if log consolidation is
turned on and multiple entries were aggregated to generate into this one.
Source This field displays the source IP address and the port number in the event that
generated the log message.
Destination This field displays the destination IP address and the port number of the event that
generated the log message.
Note This field displays any additional information about the log message.
Table 196 Log & Report > Log/Events
LABEL DESCRIPTION
To Next Page
Loading...
