Chapter 7 Interfaces
USG FLEX H Series User’s Guide
131
For example, in the figure below, the configured available bandwidth of WAN1 is 1M and WAN2 is 512K.
You can set the Zyxel Device to distribute the network traffic between the two interfaces by setting the
weight of wan1 and wan2 to 2 and 1 respectively. The Zyxel Device assigns the traffic of two sessions to
wan1 and one session's traffic to wan2 in each round of 3 new sessions.
Figure 95 Weighted Round Robin Algorithm Example
7.7 The Trunk Summary Screen
Click Network > Interface > Trunk to open the Trunk screen. The following screen lists the configured
trunks and the load balancing algorithm that each is configured to use.
To Next Page
Loading...
