Chapter 7 Interfaces
USG FLEX H Series User’s Guide
135
Each field is described in the table below.
7.8 Port
Use this screen to configure port settings. Click Network > Interface > Port in the navigation panel to
display the configuration screen.
Table 71 Network > Interface > Trunk > Default Trunk > Edit
LABEL DESCRIPTION
Name This field displays the name of the selected system default trunk.
Load Balancing
Setting
This field displays the load balancing method use for the default trunk.
Weighted Round Robin (wrr) balances the traffic load between interfaces based on their
respective weights. An interface with a larger weight gets more chances to transmit traffic
than an interface with a smaller weight. For example, if the weight ratio of wan1 and
wan2 interfaces is 2:1, the Zyxel Device chooses wan1 for 2 sessions’ traffic and wan2 for 1
session’s traffic in each round of 3 new sessions.
The table lists the trunk’s member interfaces. This table is read-only.
Name This column displays the name of the member interfaces.
Mode This field displays Active if the Zyxel Device always attempt to use this connection.
This field displays Passive if the Zyxel Device only use this connection when all of the
connections set to active are down. Only one of a group’s interfaces can be set to
passive mode.
Parameter This field displays with the weighted round robin load balancing algorithm. Specify the
weight (1~10) for the interface. The weights of the different member interfaces form a
ratio. s
Apply Click this button to save your changes to the Zyxel Device.
Reset Click this button to return the screen to its last-saved settings.
To Next Page
Loading...
