ZyXEL Communications USG FLEX H Series - User;Group Group Summary Screen

Chapter 23 User & Authentication
USG FLEX H Series User’s Guide
337
23.1.4 User/Group Group Summary Screen
User groups consist of access users and other user groups. You cannot put admin users in user groups.
The Group screen provides a summary of all user groups. In addition, this screen allows you to add, edit,
and remove user groups. To access this screen, login to the Web Configurator, and click User &
Authentication > User/Group > Group.
Figure 207 User & Authentication > User/Group > Group
Description Enter the description of each user, if any. You can use 1 to 30 single-byte characters,
including 0-9a-zA-Z!”#$%’()*+,-/:;=?@_
&.<>[\]{|}^‘are not allowed. Default descriptions are provided.
Email Type one or more valid email addresses for this user so that email messages can be sent to
this user if required. A valid email address must contain the @ character. For example, this is
a valid email address: abc@example.com.
Mobile Number Type a valid mobile telephone number for this user so that SMS messages can be sent to this
user if required. A valid mobile telephone number can be up to 20 characters in length,
including the numbers 1~9 and the following characters in the square brackets [+*#()-].
Authentication
Timeout Settings
If you want the system to use default settings, select Use Default Settings. If you want to set
authentication timeout to a value other than the default settings, select Use Manual Settings
then fill your preferred values in the fields that follow.
Lease Time If you select Use Default Settings in the Authentication Timeout Settings field, the default
lease time is shown.
If you select Use Manual Settings, you need to enter the number of minutes this user has to
renew the current session before the user is logged out. You can specify 1 to 1440 minutes.
You can enter 0 to make the number of minutes unlimited. Admin users renew the session
every time the main screen refreshes in the Web Configurator. Access users can renew the
session by clicking the Renew button on their screen. If you allow access users to renew time
automatically (see
Section 23.1.5 on page 339), the users can select this check box on their
screen as well. In this case, the session is automatically renewed before the lease time
expires.
Reauthentication
Time
If you select Use Default Settings in the Authentication Timeout Settings field, the default
reauthentication time is shown.
If you select Use Manual Settings, you need to type the number of minutes this user can be
logged into the Zyxel Device in one session before the user has to log in again. You can
specify 1 to 1440 minutes. You can enter 0 to make the number of minutes unlimited. Unlike
Lease Time, the user has no opportunity to renew the session without logging out.
Enable Two-Factor
Authentication for
Admin Access
This field is available when you are editing a local administrator account.
Enable this to require double-layer security to access a secured network behind the Zyxel
Device via the Web Configurator.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to return the screen to its last-saved settings.
Table 167 User & Authentication > User/Group > User > Add/Edit
LABEL DESCRIPTION