ZyXEL Communications USG FLEX H Series - Page 336

Chapter 23 User & Authentication
USG FLEX H Series User’s Guide
336
Figure 206 User & Authentication > User/Group > User > Add/Edit (User)
The following table describes the labels in this screen.
Table 167 User & Authentication > User/Group > User > Add/Edit
LABEL DESCRIPTION
User Name Type the user name for this user account. You may use 1-30 alphanumeric characters,
periods (.), at (@), underscores(
_), or dashes (-), but the first character cannot be a number.
This value is case-sensitive. User names have to be different than user group names, and
some words are reserved. See
Section 23.1.3.1 on page 334.
User Type Select the type of user account the Zyxel Device uses for the Local Administrator account
from the drop-down list box.
• Admin- this user can configure the Zyxel Device settings using the web configurator or
CLI.
• Viewer- this user can only view the Zyxel Device settings using the web configurator and
perform basic diagnostics for troubleshooting using the command line interface (CLI).
Select the type of user account the Zyxel Device uses for the User account from the drop-
down list box:
• User - this user has access to the Zyxel Device’s services and can also browse user-mode
commands (CLI).
• Extent User - this user account is maintained on a remote server, such as RADIUS or LDAP.
See
Ext-User Accounts on page 332 for more information about this type.
Password This field is not available if you select the Extent User type.
Enter a password consists of 4 to 64 characters for this user account, including 0-9a-zA-
Z’(){}<>^‘+/:!*#@&=$\.~%,|;-”
Retype This field is not available if you select the Extent User type.