ZyXEL Communications USG FLEX H Series - 2.5 Device Registration

Chapter 2 Initial Setup Wizard
USG FLEX H Series User’s Guide
38
Figure 22 System Time
2.5 Device Registration
Click the Register button in this screen to register your device at NCC.
You will need the Zyxel Device’s serial number and LAN MAC address to register it at NCC if you have
not already done so. Refer to the label at the back of the Zyxel Device for details.
Note: You must register your Zyxel Device at NCC to activate security services and upgrade
firmware. You cannot proceed with the initial setup wizard if you do not register your
Zyxel Device.
Note: The Zyxel Device must be connected to the Internet in order to register.