ZyXEL Communications USG FLEX H Series - The Site to Site VPN Add;Edit Screen- Wizard

Chapter 11 IPSec VPN
USG FLEX H Series User’s Guide
168
Figure 120 VPN > Site to Site VPN
Each field is discussed in the following table.
11.3.1 The Site to Site VPN Add/Edit Screen- Wizard
The Site to Site VPN Add/Edit Gateway screen allows you to create a new VPN connection policy or edit
an existing one. To access this screen, go to the VPN > Site to Site VPN screen, and click either the Add
icon or an Edit icon. Select Site-to-Site in VPN > Site to Site VPN> Add/Edit > Scenario > Type to create a
VPN rule using the wizard.
Table 85 Configuration > VPN > IPSec VPN > VPN Connection
LABEL DESCRIPTION
Global Setting The following two fields are for all IPSec VPN policies.
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify the
entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove it
before doing so.
Active To turn on an entry, select it and click Activate.
Inactive To turn off an entry, select it and click Inactivate.
Connect To connect an IPSec SA, select it and click Connect.
Disconnect To disconnect an IPSec SA, select it and click Disconnect.
Status The activate (light bulb) icon is lit when the entry is active and dimmed when the entry is
inactive.
The connect icon is lit when the interface is connected and dimmed when it is disconnected.
Name This field displays the name of the VPN rule.
Outgoing
Interface
This field displays the interface IP address or DNS name the VPN connection uses to transmit
packets.
Remote
Gateway
This field displays the remote IPSec device IP address or DNS name in use for this VPN
connection.
Type This field displays the type (route based or policy based) the VPN rule is using.
Local This field displays the IP address of the computer on your network.
Remote This field displays the IP address of the computer behind the remote IPSec device.
Config Type This field displays if the VPN rule is configured through wizard or a customized rule.
Apply Click Apply to save your changes back to the Zyxel Device.
Reset Click Reset to return the screen to its last-saved settings.