Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User’s Guide
49
The following table describes the items on the rear panel.
Note: Use an 8-wire Ethernet cable to run your Gigabit Ethernet connection at 1000 Mbps.
Using a 4-wire Ethernet cable limits your connection to 100 Mbps. Note that the
connection speed also depends on what the Ethernet device at the other end can
support.
3.2 Installation Scenarios
The Zyxel Device can be:
• Placed on a desktop.
• Wall-mounted on a wall.
• Rack-mounted on a standard EIA rack.
The following table summarizes the installation scenarios of the Zyxel Device by model.
Table 18 Rear Panel Items
LABEL DESCRIPTION
Power Use the included power cord to connect the power socket to a power outlet. Turn the power
switch on if your Zyxel Device has a power switch.
Console You can use the console port to manage the Zyxel Device using CLI commands. You will be
prompted to enter your user name and password. See the Command Reference Guide for
more information about the CLI.
When configuring using the console port, you need a computer equipped with
communications software configured to the following parameters:
• Speed 115200 bps
• Data Bits 8
•Parity None
•Stop Bit 1
• Flow Control Off
P1-P8 (USG FLEX
100H, USG FLEX
100HP)
Theses are 1G RJ-45 Ethernet ports.
Fan The fans are for cooling the Zyxel Device. Make sure they are not obstructed to allow maximum
ventilation.
Lock Attach a lock-and-cable from the Kensington lock (the small, metal-reinforced, oval hole) to a
permanent object, such as a pole, to secure the Zyxel Device in place.
Table 19 USG FLEX Series Installation Comparison Table
USG FLEX MODELS
USG FLEX 100H/USG FLEX 100HP/
USG FLEX 200H/USG FLEX 200HP
USG FLEX
500H
USG FLEX
700H
Rubber feet for desktop
placement
Yes Yes Yes
Wall Mounting Yes No No
Rack Mounting No Yes Yes
To Next Page
Loading...
