ZyXEL Communications USG FLEX H Series - Geo IP Summary Screen

Chapter 14 Object
USG FLEX H Series User’s Guide
212
Figure 145 IPv4 Address Group Configuration > Add
The following table describes the labels in this screen.
14.1.4 Geo IP Summary Screen
Use this screen to update the database of country-to-IP and continent-to-IP address mappings and
manually configure custom country-to-IP and continent-to-IP address mappings in geographic address
objects. You can then use geographic address objects in security policies to forward or deny traffic to
whole countries or regions.
Click a column’s heading cell to sort the table entries by that column’s criteria. Click the heading cell
again to reverse the sort order.
Table 108 IPv4 Address Group Configuration > Add
LABEL DESCRIPTION
Name Enter a name for the address group. You may use 2-30 single-byte characters, including 0-9a-
zA-Z, underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
Description You can use 1 to 30 single-byte characters, including 0-9a-zA-Z!”#$%’()*+,-/:;=?@_
&.<>[\]{|}^‘are not allowed.
Member List The list on the left displays the names of the address and address group objects that have
been added to the address group. The order of members is not important. Select items fro this
list that you want to be members and move them to the list on the right.
Move any members you do not want included to the list on the left.
Note: Only objects of the same address type can be added to a address group.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to return the screen to its last-saved settings.