ZyXEL Communications USG FLEX H Series - Page 52

Chapter 3 Hardware, Interfaces and Zones
USG FLEX H Series User’s Guide
52
The following table lists the distance “X” between mounting holes for each model:
1 Drill into a wall two holes 3 mm – 4 mm (0.12" – 0.16") wide, 20 mm – 30 mm (0.79” – 1.18”) deep and a
distance X (see the preceding table) apart. Place two screw anchors in the holes.
Figure 45 Wall Mounting Screw Specifications
2 Screw two screws with 6 mm – 8 mm (0.24" – 0.31") wide heads into the screw anchors. Do not screw the
screws all the way in to the wall; leave a small gap between the head of the screw and the wall.
The gap must be big enough for the screw heads to slide into the screw slots and the connection cables
to run down the back of the Zyxel Device.
Note: Make sure the screws are securely fixed to the wall and strong enough to hold the
weight of the Zyxel Device with the connection cables.
3 Use the holes on the bottom of the Zyxel Device to hang the Zyxel Device on the screws.
Table 20 Distance “X” Between FLEX Mounting Holes
MODEL NAME DISTANCE “X”
USG FLEX 100H 174 mm (6.85”)
USG FLEX 100HP 174 mm (6.85”)
USG FLEX 200H 174 mm (6.85”)
USG FLEX 200HP 206 mm (8.11”)