ZyXEL Communications USG FLEX H Series - Page 173

Chapter 11 IPSec VPN
USG FLEX H Series User’s Guide
173
Each field is described in the following table.
11.3.1.5 Summary
Use this screen to view a summary of the VPN tunnel configurations. You can click Edit to change the
VPN tunnel configuration settings.
Figure 126 VPN > Site to Site VPN > Add/Edit > Summary
Table 89 VPN > Site-to-Site VPN > Add/Edit > Policy & Routing
LABEL DESCRIPTION
Type Select Route-Based to create a VPN rule that encrypts traffic based on the static route
settings.
Select Policy-Based to create a VPN rule that encrypts traffic based on the IPv4
addresses you set in Local Subnet and Remote Subnet.
Local Subnet Type the IP address of a computer on your network that can use the tunnel. You can also
specify a subnet. This must match the remote IP address configured on the remote IPSec
device.
Remote Subnet Type the IP address of a computer behind the remote IPSec device. You can also specify
a subnet. This must match the local IP address configured on the remote IPSec device.