Chapter 11 IPSec VPN
USG FLEX H Series User’s Guide
175
Figure 128 VPN > Site to Site VPN > Add/Edit > Scenario > Type > Custom (continued)
Each field is described in the following table.
Table 90 VPN > Site-to-Site VPN > Add/Edit > Scenario > Type > Custom
LABEL DESCRIPTION
General Settings
Enable Slide the switch to the right to activate this VPN connection
Name Type the name used to identify this rule. You may use 1-31 single-byte characters,
including 0-9a-zA-Z, underscores (
_), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
IKE Version Select IKEv1 or IKEv2. IKEv1 applies to IPv4 traffic only. IKEv2 applies to both IPv4 and IPv6
traffic. IKE (Internet Key Exchange) is a protocol used in setting up security associations
that allows two parties to send data securely. See
Section 11.1 on page 158 for more
information on IKEv1 and IKEv2.
Type Select Route-Based to create a VPN rule that encrypts traffic based on the static route
settings.
Select Policy-Based to create a VPN rule that encrypts traffic based on the Local and
Remote IPv4 addresses you set in Policy in Phase 2 Settings.
Network
To Next Page
Loading...
