Chapter 13 Security Policy
USG FLEX H Series User’s Guide
196
Figure 136 Security Policy > Policy Control > Add
The following table describes the labels in this screen.
Table 96 Security Policy > Policy Control > Add
LABEL DESCRIPTION
Enable Select this check box to activate the policy control.
Name Type a name with 1 to 30 single-byte characters to identify the policy, including a-zA-Z0-9.
Special characters and spaces are not allowed.
Description Enter a descriptive name of 1 to 30 single-byte characters for the policy, including spaces and 0-
9a-zA-Z!”#$%()*+,-/:;=?@_
&.<>[\]^‘{|} are not allowed.
From
To
For through-Zyxel Device policies, select the direction of travel of packets to which the policy
applies.
any means all interfaces.
ZyWALL means packets destined for the Zyxel Device itself.
Source Select an IPv4 address or address group object, including geographic address and FQDN
(group) objects, to apply the policy to traffic coming from it. Select any to apply the policy to all
traffic coming from IPv4 addresses.
Destination Select an IPv4 address or address group, including geographic address and FQDN (group)
objects, to apply the policy to traffic going to it. Select any to apply the policy to all traffic going
to IPv4 addresses.
Service Select a service or service group from the drop-down list box.
To Next Page
Loading...
