Chapter 1 Introduction
USG FLEX H Series User’s Guide
20
Figure 5 Managing the Zyxel Device: Web Configurator
Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the Zyxel Device. Access it using remote
management (for example, SSH) or via the physical port. See the Command Reference Guide for CLI
details. The default settings for the console port are:
FTP
Use File Transfer Protocol for firmware upgrades and configuration backup or restore.
SNMP
The device can be monitored and/or managed by an SNMP manager. See Section 24.3 on page 356.
Management Authentication
Managers must be authenticated with a username and password, using one of:
• Local Zyxel Device authentication
• An external RADIUS server
Table 3 Console Port Default Settings
SETTING VALUE
Speed 115200 bps
Data Bits 8
Parity None
Stop Bit 1
Flow Control Off
To Next Page
Loading...
