ZyXEL Communications USG FLEX H Series - Page 219

Chapter 14 Object
USG FLEX H Series User’s Guide
219
14.2.2.1 The Service Add/Edit Screen
The Service Add/Edit screen allows you to create a new service or edit an existing one. To access this
screen, go to the Service screen (see
Section 14.2.2 on page 217), and click either the Add icon or an
Edit icon.
Figure 150 Object > Service > Service > Add/Edit
The following table describes the labels in this screen.
Table 112 Object > Service > Service > Add/Edit
LABEL DESCRIPTION
Name Type the name used to refer to the service. You may use 1-30 single-byte characters, including
0-9a-zA-Z!”#$%’()*+,-/:;=?@_, but the first character cannot be a number. &.<>[\]{|}^‘are not
allowed.
This value is case-sensitive.
Description Type the description used to refer to the service. You may use 1-30 single-byte characters,
including 0-9a-zA-Z!”#$%’()*+,-/:;=?@_, but the first character cannot be a number.
&.<>[\]{|}^‘are not allowed.
IP Protocol Select the protocol the service uses. Choices are: TCP, UDP, ICMP, ICMPv6, and User Defined.
Starting Port
Ending Port
This field appears if the IP Protocol is TCP or UDP. Specify the port number(s) used by this service.
If you fill in one of these fields, the service uses that port. If you fill in both fields, the service uses
the range of ports.
ICMP Type This field appears if the IP Protocol is ICMP or ICMPv6.
Select the ICMP message used by this service. This field displays the message text, not the
message number.
IP Protocol
Number
This field appears if the IP Protocol is User Defined.
Enter the number of the next-level protocol (IP protocol). Allowed values are 1 - 255.
Apply Click Apply to save your customized settings and exit this screen.
Reset Click Reset to return the screen to its last-saved settings.