Chapter 26 File Manager
USG FLEX H Series User’s Guide
406
E-mail Subject Enter a email subject text with 1-60 characters. It may consist of letters, numbers, and the
following special characters: ‘()+,./:=?;!*#@$%-
Email To Enter the receiving email address. You and send the configuration file to a maximum of five
email addresses.
Email
Content
Enter the backup email body text using 1 to 251 single-byte characters, including 0-9a-zA-
Z!”#$%&’()*+,-./:;<=>@[\]^_‘{|} and spaces are allowed.
? is not allowed.
Send Email Click this to send the email to the email address you configured.
Cancel Click this to close the screen.
Upload Click this to upload a new or previously saved configuration file from your computer to your
Zyxel Device
You cannot upload a configuration file named system-default.conf or lastgood.conf.
If you upload startup-config.conf, it will replace the current configuration and immediately
apply the new settings.
File Path Type in the location of the file you want to upload in this field or click Browse ... to find it.
Browse... Click Browse... to find the .conf file you want to upload. The configuration file must use a
“.conf” filename extension. You will receive an error message if you try to upload a fie of a
different format. Remember that you must decompress compressed (.zip) files before you can
upload them.
Upload Click Upload to begin the upload process. This process may take up to two minutes.
Cancel Click this to close the screen.
File Name This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file names.
The system-default.conf file contains the Zyxel Device’s default settings. Select this file and click
Apply to reset all of the Zyxel Device settings to the factory defaults. This configuration file is
included when you upload a firmware package.
The startup-config.conf file is the configuration file that the Zyxel Device is currently using. If you
make and save changes during your management session, the changes are applied to this
configuration file. The Zyxel Device applies configuration changes made in the Web
Configurator to the configuration file when you click Apply or OK. It applies configuration
changes made via commands when you use the write command.
The lastgood.conf is the most recently used (valid) configuration file that was saved when the
device last restarted. If you upload and apply a configuration file with an error, you can apply
lastgood.conf to return to a valid configuration.
Size This column displays the size (in KB) of a configuration file.
Last Modified This column displays the date and time that the individual configuration files were last
changed or saved.
Configure
Backup Schedule
Enable Auto
Backup
Select the check box to back up the configuration file at a user defined schedule.
Note: After the first backup, the back up only occurs if the configuration file is
different from the previous backed up configuration file.
Daily Set the Zyxel Device to back up its configuration file once a day at the specified hour and
minute.
Weekly Set the Zyxel Device to back up its configuration file once a week on the specified day, at the
specified hour and minute.
Table 200 Maintenance > File Manager > Configuration File (continued)
LABEL DESCRIPTION
To Next Page
Loading...
