ZyXEL Communications VPN Series - VPN Settings for Configuration Provisioning Express Wizard - Summary

Chapter 5 Quick Setup Wizards
ZyWALL/USG Series User’s Guide
149
Figure 122 VPN for Configuration Provisioning Express Wizard: Configuration
• Secure Gateway: Any displays in this field because it is not configurable in this wizard. It allows
incoming connections from the ZyWALL/USG IPSec VPN Client.
• Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same password.
Use 8 to 31 case-sensitive ASCII characters or 8 to 31 pairs of hexadecimal (“0-9”, “A-F”)
characters. Proceed a hexadecimal key with “0x”. You will receive a PYLD_MALFORMED (payload
malformed) packet if the same pre-shared key is not used on both ends.
• Local Policy (IP/Mask): Type the IP address of a computer on your network. You can also
specify a subnet. This must match the remote IP address configured on the remote IPSec device.
• Remote Policy (IP/Mask): Any displays in this field because it is not configurable in this
wizard.
5.4.3 VPN Settings for Configuration Provisioning Express Wizard -
Summary
This screen has a read-only summary of the VPN tunnel’s configuration and commands you can
copy and paste into another ZLD-based ZyWALL/USG’s command line interface to configure it.