ZyXEL Communications VPN Series - Default Zones, Interfaces, and Ports

Chapter 3 Hardware, Interfaces and Zones
ZyWALL/USG Series User’s Guide
68
Figure 48 Wall Mounting
3.3 Default Zones, Interfaces, and Ports
The default configurations for zones, interfaces, and ports are as follows. References to interfaces
may be generic rather than the specific name used in your model. For example, this guide may use
“the WAN interface” rather than “wan1” or “wan2”, “ge2” or” ge3”.
An OPT (optional) Ethernet port can be configured as an additional WAN port, LAN, WLAN, or DMZ
port.
The following table shows the default physical port and interface mapping for each model at the
time of writing.
Screw Specifications
Table 17 Default Physical Port - Interface Mapping
PORT / INTERFACE P1 P2 P3 P4 P5 P6 P7 P8
•USG40
wan1 lan1 lan1 lan1 opt
• USG40W
wan1 lan1 lan1 lan1 opt
• USG20-VPN
sfp wan lan1 lan1 lan1 lan1
• USG20W-VPN
sfp wan lan1 lan1 lan1 lan1
•USG60
wan1 wan2 lan1 lan1 lan1 lan1
• USG60W
wan1 wan2 lan1 lan1 lan1 lan1