Chapter 26 Walled Garden
ZyWALL/USG Series User’s Guide
504
26.4.1 Adding/Editing a Walled Garden Domain or IP
Go to the Configuration > Hotspot > Walled Garden > Domain/IP Base screen. Click Add or
select an entry and click the Edit to open the Add/Edit Walled Garden Domain/IP screen. Use
this screen to configure the domain name or IP address entry for a walled garden web site.
Figure 353 Configuration > Hotspot > Walled Garden: Domain/IP Base: Add/Edit
The following table describes the labels in this screen.
26.4.2 Walled Garden Login Example
The following figure shows the user login screen with two walled garden links. The links are named
WalledGardenLink1 through 2 for demonstration purposes.
Domain Name/IP
Address
This field displays the domain name or IP address and subnet mask of the web site.
Apply Click this button to save your changes to the ZyWALL/USG.
Reset Click this button to return the screen to its last-saved settings.
Table 190 Configuration > Hotspot > Walled Garden: Domain/IP Based (continued)
LABEL DESCRIPTION
Table 191 Configuration > Hotspot > Walled Garden: Domain/IP Base: Add/Edit
LABEL DESCRIPTION
Enable Select this to activate the entry.
Name Enter a descriptive name for the walled garden link.
You can use up to 31 alphanumeric characters (A-Z, a-z, 0-9) and underscores (_). Spaces
are also allowed. The first character must be a letter.
Type Select whether you want to create the link by entering a domain name or an IP address.
Domain Name /
IP Address
If you select Domain, type a Fully-Qualified Domain Name (FQDN) of a web site. An FQDN
starts with a host name and continues all the way up to the top-level domain name. For
example, www.zyxel.com.tw is a fully qualified domain name, where “www” is the host,
“zyxel” is the third-level domain, “com” is the second-level domain, and “tw” is the top
level domain. Underscores are not allowed. Use "*." as a prefix in the FQDN for a wildcard
domain name (for example, *.example.com).
If you select IP, enter the IP address and subnet mask of the web site.
OK Click OK to save your changes back to the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
