Chapter 42 Object
ZyWALL/USG Series User’s Guide
773
42.6.4.1 Add Custom IPv4/IPv6 Address to Geography Screen
This screen allows you to create a new geography-to-IP address mapping. To access this screen, go
to the Geo IP screen (see Section 42.6.4 on page 771), and click the Add icon in the Custom
IPv4 to Geography Rules or Custom IPv6 to Geography Rules section.
Figure 530 Geo IP > Add
The following table describes the labels in this screen.
42.7 Service Overview
Use service objects to define TCP applications, UDP applications, and ICMP messages. You can also
create service groups to refer to multiple service objects in other features.
•Use the Service screens (Section 42.7.2 on page 775) to view and configure the ZyWALL/USG’s
list of services and their definitions.
Type This field displays whether this address object is HOST, RANGE or SUBNET.
IPv4 Address This field displays the IPv4 addresses represented by the type of address object.
Table 312 Configuration > Object > Address/Geo IP > Geo IP (continued)
LABEL DESCRIPTION
Table 313 Geo IP > Add
LABEL DESCRIPTION
Country Select the country or region that maps to this IP address.
Address Type Select the type of address you want to create. Choices are: HOST, RANGE, SUBNET.
IP Address This field is only available if the Address Type is HOST. This field cannot be blank. Enter
the IP address that this address object represents.
IP Starting
Address
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the beginning of the range of IP addresses that this address object represents.
IP Ending
Address
This field is only available if the Address Type is RANGE. This field cannot be blank.
Enter the end of the range of IP address that this address object represents.
Network /
Netmask
These fields are only available if the IPv4 Address Type is SUBNET. They cannot be
blank. Enter the network IP and subnet mask that defines the IPv4 subnet.
IPv6 Address
Prefix
This field is only available if the IPv6 Address Type is SUBNET. This field cannot be
blank. Enter the IPv6 address prefix that the ZyWALL/USG uses for the LAN IPv6 address.
OK Click OK to save your changes back to the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving your changes.
To Next Page
Loading...
