Chapter 6 Dashboard
ZyWALL/USG Series User’s Guide
173
6.2.10 Extension Slot Screen
Figure 145 Dashboard > Extension Slot
This table describes the fields in the above screen.
6.2.11 Interface Status Summary Screen
Interfaces per ZyWALL/USG model vary.
Table 33 Dashboard > Extension Slot
LABEL DESCRIPTION
# This is the index number of the entry.
Extension Slot This field displays the name of each extension slot.
Device This field displays the name of the device connected to the extension slot (or
none if no device is detected). For an installed SEM (Security Extension Module)
card, this field displays what kind of SEM card is installed.
SEM-VPN - VPN accelerator. The SEM-VPN provides 500 Mbps VPN throughput,
2,000 IPSec VPN tunnels, and 750 SSL VPN users.
SEM-DUAL - accelerator for both VPN and UTM. The SEM-DUAL provides the
benefits of the SEM-VPN and increases the maximum anti-virus and IDP traffic
throughput from 100 Mbps to 400 Mbps.
USB Flash Drive - Indicates a connected USB storage device and the drive’s
storage capacity.
Status The status for an installed 3G USB dongle is none. For cellular (mobile
broadband) interfaces, see Section 7.11 on page 196 for the status that can
appear. For an installed SEM (Security Extension Module) card, this field displays
one of the following:
Active - The SEM card is working properly.
Ready to activate - The SEM was inserted while the ZyWALL/USG was
operating. Restart the ZyWALL/USG to use the SEM.
Driver load failed - An error occurred during the ZyWALL/USG’s attempt to
activate the SEM card. Make sure the SEM is installed properly and the
thumbscrews are tightened. If this status still displays, contact your vendor.
For a USB storage device, this field displays one of the following:
Ready - A USB storage device connected to the ZyWALL/USG is ready for the
ZyWALL/USG to use.
Unused - The ZyWALL/USG is unable to mount a USB storage device connected
to the ZyWALL/USG.
To Next Page
Loading...
