Chapter 4 Easy Mode
ZyWALL/USG Series User’s Guide
86
4.5 Initial Setup Wizard Screen 9 - Guest LAN
Figure 62 Initial Setup Wizard 9
Select Enable Guest Network (for wired clients) to convert the OPT or P6 port (depending on
your model) to be a guest port and isolate it from the LAN/DMZ ports. Devices connected to the
guest port are allowed Internet access only and do not have access to networks connected to the
other ports.
When the OPT or P6 port is not a guest port, then guest devices connected to that port can
communicate with all networks, including devices connected to the LAN/DMZ ports. If that is not
your intention, make sure Enable Guest Network (for wired clients) is selected and that guest
devices are only connected to the OPT or P6 port on the ZyWALL/USG.
To Next Page
Loading...
