ZyXEL Communications VPN Series - Web Configurator

Chapter 1 Introduction
ZyWALL/USG Series User’s Guide
29
Figure 7 Managing the ZyWALL/USG: Web Configurator
Command-Line Interface (CLI)
The CLI allows you to use text-based commands to configure the ZyWALL/USG. Access it using
remote management (for example, SSH or Telnet) or via the physical or Web Configurator console
port. See the Command Reference Guide for CLI details. The default settings for the console port
are:
FTP
Use File Transfer Protocol for firmware upgrades and configuration backup/restore.
SNMP
The device can be monitored and/or managed by an SNMP manager. See Section 43.3 on page 359.
CloudCNM
Use the CloudCNM screen (see Section 43.13 on page 870) to enable and configure management
of the ZyWALL/USG by a Central Network Management system.
1.3 Web Configurator
In order to use the Web Configurator, you must:
Table 2 Console Port Default Settings
SETTING VALUE
Speed 115200 bps
Data Bits 8
Parity None
Stop Bit 1
Flow Control Off