Chapter 22 Printer Manager
ZyWALL/USG Series User’s Guide
487
The following table describes the labels in this screen.
22.3 The Printout Configuration Screen
Use this screen to customize the account printout. Click Configuration > Hotspot > Printer
Manager > Printout Configuration to open the following screen.
Figure 341 Configuration > Hotspot > Printer Manager > Printout Configuration
Table 180 Configuration > Hotspot > Printer Manager > General > Discover Printer: Edit
LABEL DESCRIPTION
General Settings
Nickname Type an optional friendly name for the printer. A nickname must begin with a letter and
cannot exceed 15 characters. Valid characters are [a-zA-Z0-9_-].
IP Address Assignment
Get
Automatically
Select this to make the printer a DHCP client and automatically get the IP address, subnet
mask, and gateway address from a DHCP server.
Use Fixed IP
Address
Select this if you want to specify the IP address, subnet mask, and gateway manually.
IP Address This field is enabled if you select Use Fixed IP Address.
Enter the IP address for the printer.
Subnet Mask This field is enabled if you select Use Fixed IP Address.
Enter the subnet mask of the printer in dot decimal notation. The subnet mask indicates
what part of the IP address is the same for all computers in the network.
Gateway This field is enabled if you select Use Fixed IP Address.
Enter the IP address of the gateway. The ZyWALL/USG sends packets to the gateway when
it does not know how to route the packet to its destination. The gateway should be on the
same network as the printer.
OK Click OK to save your changes back to the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
