Chapter 10 Interfaces
ZyWALL/USG Series User’s Guide
286
10.3.4 Object References
When a configuration screen includes an Object Reference icon, select a configuration object and
click Object Reference to open the Object References screen. This screen displays which
configuration settings reference the selected object. The fields shown vary with the type of object.
Figure 219 Object References
IP Address
Assignment
IP Address Enter the IP address for this interface.
Subnet Mask Enter the subnet mask of this interface in dot decimal notation. The subnet mask
indicates what part of the IP address is the same for all computers in the network.
Gateway Enter the IP address of the gateway. The ZyWALL/USG sends packets to the gateway
when it does not know how to route the packet to its destination. The gateway should
be on the same network as the interface.
Metric Enter the priority of the gateway (if any) on this interface. The ZyWALL/USG decides
which gateway to use based on this priority. The lower the number, the higher the
priority. If two or more gateways have the same priority, the ZyWALL/USG uses the one
that was configured first.
Interface
Parameters
Egress
Bandwidth
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL/USG can send
through the interface to the network. Allowed values are 0 - 1048576.
Ingress
Bandwidth
This is reserved for future use.
Enter the maximum amount of traffic, in kilobits per second, the ZyWALL/USG can
receive from the network through the interface. Allowed values are 0 - 1048576.
OK Click OK to save your changes back to the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving.
Table 101 Configuration > Network > Interface > Create Virtual Interface (continued)
LABEL DESCRIPTION
To Next Page
Loading...
