Chapter 42 Object
ZyWALL/USG Series User’s Guide
725
42.1.2.1 Zone Edit
The Zone Edit screen allows you to add or edit a zone. To access this screen, go to the Zone
screen (see Section 42.8.2 on page 779), and click the Add icon or an Edit icon.
Figure 494 Configuration > Object > Zone > Add
The following table describes the labels in this screen.
42.2 User/Group Overview
This section describes how to set up user accounts, user groups, and user settings for the ZyWALL/
USG. You can also set up rules that control when users have to log in to the ZyWALL/USG before
the ZyWALL/USG routes traffic for them.
•The User screen (see Section 42.14.1 on page 819) provides a summary of all user accounts.
Table 279 Configuration > Object > Zone > Add/Edit
LABEL DESCRIPTION
Name For a system default zone, the name is read only.
For a user-configured zone, type the name used to refer to the zone. You may use 1-31
alphanumeric characters, underscores (
_), or dashes (-), but the first character cannot
be a number. This value is case-sensitive.
Member List Available lists the interfaces and VPN tunnels that do not belong to any zone. Select
the interfaces and VPN tunnels that you want to add to the zone you are editing, and
click the right arrow button to add them.
Member lists the interfaces and VPN tunnels that belong to the zone. Select any
interfaces that you want to remove from the zone, and click the left arrow button to
remove them.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
