Chapter 1 Introduction
ZyWALL/USG Series User’s Guide
30
• Use one of the following web browser versions or later:
• Internet Explorer 10.x, 11.x
• Chrome latest version (45 or above)
• Firefox latest version (45 or above)
• Safari latest version (9.0 or avove)
• Allow pop-up windows (blocked by default in Windows XP Service Pack 2)
• Enable JavaScripts, Java permissions, and cookies
The recommended screen resolution is 1024 x 768 pixels.
Note: Most screen shots in this guide come from the USG110 and USG60W. Screen shots
for other models may vary a little.
1.3.1 Web Configurator Access
1 Make sure your ZyWALL/USG hardware is properly connected. See the Quick Start Guide.
2 In your browser go to http://192.168.1.1. By default, the ZyWALL/USG automatically routes this
request to its HTTPS server, and it is recommended to keep this setting. The Login screen appears.
3 Type the user name (default: “admin”) and password (default: “1234”).
If you have a OTP (One-Time Password) token generate a number and enter it in the One-Time
Password field. The number is only good for one login. You must use the token to generate a new
number the next time you log in.
4 Click Login. After you log in for the first time using the default user name and password, you must
change the default admin password in the Update Admin Info screen. Type a new password of up
to 63 printable characters without spaces, then click Apply.
To Next Page
Loading...
