Chapter 10 Interfaces
ZyWALL/USG Series User’s Guide
344
10.10.2 VTI Screen
To access this screen, click Configuration > Network > Interface > VTI.
Figure 242 Configuration > Network > Interface > VTI
The following table describes the fields in this screen.
10.10.3 VTI Add/Edit
This screen lets you configure IP address assignment and interface parameters for VTI.
Note: You should have created a VPN tunnel for a Vpn Tunnel Interface scenario first.
To access this screen, click the Add or Edit icon in Network > Interface > VTI. The following
screen appears.
Table 121 Configuration > Network > Interface > VTI
LABEL DESCRIPTION
Configuration
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where you can modify
the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL/USG confirms you want
to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
Object References Select an entry and click Object Reference to open a screen that shows which
settings use the entry.
# This field is a sequential value, and it is not associated with any interface.
Status This icon is lit when the entry is active and dimmed when the entry is inactive.
Name This field displays the name of the LAG interface.
IP Address This field displays the current IP address of the virtual interface and subnet mask in
bits. If the IP address is 0.0.0.0, the interface does not have an IP address yet.
vpn-rule This shows the name of the associated IPSec VPN rule with Vpn Tunnel Interface
application scenario.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
