ZyXEL Communications VPN Series - The Redirect Service Edit Screen

Chapter 14 Redirect Service
ZyWALL/USG Series User’s Guide
399
14.2.1 The Redirect Service Edit Screen
Click Network > Redirect Service to open the Redirect Service screen. Then click the Add or
Edit icon to open the Redirect Service Edit screen where you can configure the rule.
Figure 277 Network > Redirect Service > Edit
The following table describes the labels in this screen.
Interface This is the interface on which the request must be received.
Source Address This is the name of the source IP address object from which the traffic should be sent.
If any displays, the rule is effective for every source.
Server This is the IP address of the HTTP proxy server or the SMTP server to which the
matched traffic is forwarded.
Port This is the service port number used by the HTTP proxy server or SMTP server.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
Table 146 Configuration > Network > Redirect Service (continued)
LABEL DESCRIPTION
Table 147 Network > Redirect Service > Edit
LABEL DESCRIPTION
Enable Use this option to turn the Redirect Service rule on or off.
Service Select the service to be redirected: HTTP Redirect or SMTP redirect.
Name Enter a name to identify this rule. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
Criteria