ZyXEL Communications VPN Series - Configuring the OSPF Screen

Chapter 11 Routing
ZyWALL/USG Series User’s Guide
376
OSPF Configuration
Follow these steps when you configure OSPF on the ZyWALL/USG.
1 Enable OSPF.
2 Set up the OSPF areas.
3 Configure the appropriate interfaces. See Section 10.3.1 on page 269.
4 Set up virtual links, as needed.
11.7.1 Configuring the OSPF Screen
Use the first OSPF screen to specify the OSPF router the ZyWALL/USG uses in the OSPF AS and
maintain the policies for redistribution. In addition, it provides a summary of OSPF areas, allows
you to remove them, and opens the OSPF Add/Edit screen to add or edit them.
Click Configuration > Network > Routing > OSPF to open the following screen.
Figure 262 Configuration > Network > Routing > OSPF
The following table describes the labels in this screen. See Section 11.7.2 on page 377 for more
information as well.
Table 138 Configuration > Network > Routing Protocol > OSPF
LABEL DESCRIPTION
OSPF Router ID Select the 32-bit ID the ZyWALL/USG uses in the OSPF AS.
Default - the first available interface IP address is the ZyWALL/USG’s ID.
User Defined - enter the ID (in IP address format) in the field that appears when
you select User Define.
Redistribute