Chapter 4 Easy Mode
ZyWALL/USG Series User’s Guide
82
4.2.6 Initial Setup Wizard Screen 6 - Congratulations
Figure 59 Initial Setup Wizard 6
This screen shows if your Internet access is successfully configured. You can save changes and exit
the Initial Wizard here by clearing Security Service, Port Forwarding, Guest LAN and VPN
service selections and clicking Finish. Alternatively, select desired security services to continue
configuring them as part of the Initial Wizard (Finish becomes Continue). If you want to
configure these services later you can access them from the tabs in the dashboard.
Select from the following to continue configuring in this screen:
• Security Service (Content Filter, IDP, Anti Virus) to configure subscriptions for these
services
• Port Forwarding to set up a server in your network that people outside the network can access
• Guest LAN (Wired Network) to set up a guest network where users can access the Internet
only from a wired connection to the OPT port for a limited time
• VPN for a site-to-site tunnel between ZyWALL/USG networks, a tunnel from a remote client
using the Zyxel client VPN software to the ZyWALL/USG network, or a tunnel from a remote client
using other VPN software to the ZyWALL/USG network.
A restore point is a recovery point where you can reset the ZyWALL/USG’s configuration to if you
have problems later.
To Next Page
Loading...
