Chapter 7 Monitor
ZyWALL/USG Series User’s Guide
211
7.15.7 Detected Device
Use this screen to view information about wireless devices detected by the AP. Click Monitor >
Wireless > Detected Device to access this screen.
Note: At least one radio of the APs connected to the ZyWALL/USG must be set to monitor
mode (in the Configuration > Wireless > AP Management screen) in order to
detect other wireless devices in its vicinity.
Figure 174 Monitor > Wireless > Detected Device
The following table describes the labels in this screen.
Tx Rate This field displays the transmit data rate of the station.
Rx Rate This field displays the receive data rate of the station.
Association Time This field displays the time duration the station was online and offline.
Table 64 Monitor > Wireless > Station List
LABEL DESCRIPTION
Table 65 Monitor > Wireless > Detected Device
LABEL DESCRIPTION
Mark as Rogue
AP
Click this button to mark the selected AP as a rogue AP. A rogue AP can be contained in the
Configuration > Wireless > MON Mode screen.
Mark as Friendly
AP
Click this button to mark the selected AP as a friendly AP. For more on managing friendly
APs, see the Configuration > Wireless > MON Mode screen.
# This is the station’s index number in this list.
Status This indicates the detected device’s status.
Device This indicates the detected device’s network type (such as infrastructure or ad-hoc).
Role This indicates the detected device’s role (such as friendly or rogue).
To Next Page
Loading...
