ZyXEL Communications VPN Series - The Ipsec Monitor Screen

Chapter 7 Monitor
ZyWALL/USG Series User’s Guide
213
7.17 The IPSec Monitor Screen
You can use the IPSec Monitor screen to display and to manage active IPSec To access this
screen, click Monitor > VPN Monitor > IPSec. The following screen appears. SAs. Click a
column’s heading cell to sort the table entries by that column’s criteria. Click the heading cell again
to reverse the sort order.
Figure 176 Monitor > VPN Monitor > IPSec
Each field is described in the following table.
Table 67 Monitor > VPN Monitor > IPSec
LABEL DESCRIPTION
Name Type the name of a IPSec SA here and click Search to find it (if it is associated).
You can use a keyword or regular expression. Use up to 30 alphanumeric and
_+-.()!$*^:?|{}[]<>/ characters. See Section 7.17.1 on page 214 for more
details.
Policy Type the IP address(es) or names of the local and remote policies for an IPSec SA
and click Search to find it. You can use a keyword or regular expression. Use up
to 30 alphanumeric and _+-.()!$*^:?|{}[]<>/ characters. See Section 7.17.1
on page 214 for more details.
Search Click this button to search for an IPSec SA that matches the information you
specified above.
Disconnect Select an IPSec SA and click this button to disconnect it.
# This field is a sequential value, and it is not associated with a specific SA.
Name This field displays the name of the IPSec SA.
Policy This field displays the content of the local and remote policies for this IPSec SA.
The IP addresses, not the address objects, are displayed.
IKE Name This field displays the Internet Key Exchange (IKE) name.
Cookies This field displays the cookies information that initiates the IKE.
My Address This field displays the IP address of local computer.
Secure Gateway This field displays the secure gateway information.
Up Time This field displays how many seconds the IPSec SA has been active. This field
displays N/A if the IPSec SA uses manual keys.
Timeout This field displays how many seconds remain in the SA life time, before the
ZyWALL/USG automatically disconnects the IPSec SA. This field displays N/A if
the IPSec SA uses manual keys.
Inbound (Bytes) This field displays the amount of traffic that has gone through the IPSec SA from
the remote IPSec router to the ZyWALL/USG since the IPSec SA was established.
Outbound (Bytes) This field displays the amount of traffic that has gone through the IPSec SA from
the ZyWALL/USG to the remote IPSec router since the IPSec SA was established.