Chapter 5 Quick Setup Wizards
ZyWALL/USG Series User’s Guide
159
• My Address (interface): Select one of the interfaces from the pull down menu to apply the
L2TP VPN rule.
• Pre-Shared Key: Type the password. Both ends of the VPN tunnel must use the same password.
Use 8 to 31 case-sensitive ASCII characters or 8 to 31 pairs of hexadecimal (“0-9”, “A-F”)
characters. Proceed a hexadecimal key with “0x”. You will receive a PYLD_MALFORMED (payload
malformed) packet if the same pre-shared key is not used on both ends.
Click Next to continue the wizard.
5.5.2 L2TP VPN Settings
Figure 132 VPN Settings for L2TP VPN Settings Wizard: L2TP VPN Settings
• IP Address Pool: Select Range or Subnet from the pull down menu. This IP address pool is used
to assign to the L2TP VPN clients.
• Starting IP Address: Enter the starting IP address in the field.
• End IP Address: Enter the ending IP address in the field.
• First DNS Server (Optional): Enter the first DNS server IP address in the field. Leave the filed
as 0.0.0.0 if you do not want to configure DNS servers. If you do not configure a DNS server you
must know the IP address of a machine in order to access it.
• Second DNS Server (Optional):Enter the second DNS server IP address in the field. Leave the
filed as 0.0.0.0 if you do not want to configure DNS servers. If you do not configure a DNS server
you must know the IP address of a machine in order to access it.
• Allow L2TP traffic Through WAN: Select this check box to allow traffic from L2TP clients to go
to the Internet.
Click Next to continue the wizard.
To Next Page
Loading...
