ZyXEL Communications VPN Series - Service Control Rules; Customizing the WWW Login Page

Chapter 43 System
ZyWALL/USG Series User’s Guide
844
43.7.5 Service Control Rules
Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or SNMP screen to
add a service control rule.
Figure 584 Configuration > System > Service Control Rule > Edit
The following table describes the labels in this screen.
43.7.6 Customizing the WWW Login Page
Click Configuration > System > WWW > Login Page to open the Login Page screen. Use this
screen to customize the Web Configurator login screen. You can also customize the page that
displays after an access user logs into the Web Configurator to access network services like the
Internet.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
Table 356 Configuration > System > WWW > Service Control (continued)
LABEL DESCRIPTION
Table 357 Configuration > System > Service Control Rule > Edit
LABEL DESCRIPTION
Create new
Object
Use this to configure any new settings objects that you need to use in this screen.
Address Object Select ALL to allow or deny any computer to communicate with the ZyWALL/USG using this
service.
Select a predefined address object to just allow or deny the computer with the IP address
that you specified to access the ZyWALL/USG using this service.
Zone Select ALL to allow or prevent any ZyWALL/USG zones from being accessed using this
service.
Select a predefined ZyWALL/USG zone on which a incoming service is allowed or denied.
Action Select Accept to allow the user to access the ZyWALL/USG from the specified computers.
Select Deny to block the user’s access to the ZyWALL/USG from the specified computers.
OK Click OK to save your customized settings and exit this screen.
Cancel Click Cancel to exit this screen without saving