ZyXEL Communications VPN Series - Initial Setup Wizard Screen 4 - Wi-Fi

Chapter 4 Easy Mode
ZyWALL/USG Series User’s Guide
80
4.2.4 Initial Setup Wizard Screen 4 - Wi-Fi
Figure 57 Initial Setup Wizard 4
Select Enable Wi-Fi Network if you want wireless devices to be able to wirelessly access the
ZyWALL/USG and all resources connected to the ZyWALL/USG. Configure a descriptive name of
from 1 to 32 alpha-numeric characters, hyphens or underscores (a-z A-Z 0-9 -_) for the wireless
network name (Wi-Fi). Set a Password of between 8 and 63 printable ASCII characters (including
spaces and symbols) or 64 hexadecimal characters (0-9 a-f) that wireless users will have to enter
for access to the ZyWALL/USG wireless network.
Select Enable Guest Wi-Fi Network if you want wireless devices to only be able to wirelessly
access the Internet via the ZyWALL/USG for up to 4 hours. Configure a descriptive name of from 1
to 32 alpha-numeric characters, hyphens or underscores (a-z A-Z 0-9 -_) for the wireless network
name (Wi-Fi). Set a Password of between 8 and 63 printable ASCII characters (including spaces
and symbols) or 64 hexadecimal characters (0-9 a-f) that wireless users will have to enter for
access to the ZyWALL/USG Guest wireless network.
The Guest Wi-Fi Network allows Internet access only for up to 4 hours by default. Log in again if the
time has elapsed. You can change the default time for Guest Wi-Fi access in the Wi-Fi and Guest
Wizard.
The ZyWALL/USG uses WPA2-PSK with AES encryption so wireless clients must be able to support
AES encryption to wirelessly connect to the ZyWALL/USG using WPA2-PSK.