Chapter 43 System
ZyWALL/USG Series User’s Guide
870
43.12.1 Add/Edit Trusted RADIUS Client
Click Configuration > System > Auth. Server to display the Auth. Server screen. Click the Add
icon or an Edit icon to display the following screen. Use this screen to create a new entry or edit an
existing one.
Figure 616 Configuration > System > Auth. Server > Add/Edit
The following table describes the labels in this screen.
43.13 CloudCNM Screen
CloudCNM is a cloud-based network management system that allows management and monitoring
of ZyWALL/USG/UAG security gateways with firmware that supports the TR-069 protocol.
In the following figure, SP is the management service provider, while A and B are sites with devices
being managed by SP.
Table 366 Configuration > System > Auth. Server > Add/Edit
LABEL DESCRIPTION
Activate Select this check box to make this profile active.
Profile Name Enter a descriptive name (up to 31 alphanumerical characters) for identification purposes.
IP Address Enter the IP address of the RADIUS client that is allowed to exchange messages with the
ZyWALL/USG.
Netmask Enter the subnet mask of the RADIUS client.
Secret Enter a password (up to 64 alphanumeric characters) as the key to be shared between the
ZyWALL/USG and the RADIUS client.
The key is not sent over the network. This key must be the same on the external
authentication server and the ZyWALL/USG.
Description Enter the description of each server, if any. You can use up to 60 printable ASCII
characters.
OK Click OK to save the changes.
Cancel Click Cancel to discard the changes.
To Next Page
Loading...
