Chapter 9 Wireless
ZyWALL/USG Series User’s Guide
247
9.3.3 AP Group
Use this screen to configure AP groups, which define the radio, port, VLAN and load balancing
settings and apply the settings to all APs in the group. An AP can belong to one AP group at a time.
Click Configuration > Wireless > AP Management > AP Group to access this screen.
Figure 202 Configuration > Wireless > AP Management > AP Group
Each field is described in the following table.
Table 87 Configuration > Wireless > AP Management > AP Group
LABEL DESCRIPTION
Group Setting
Default Group Select a group that is used as the default group.
Any AP that is not configured to associate with a specific AP group belongs to the
default group automatically.
Group Summary
Edit Select an entry and click this button to edit its properties.
Remove Select an entry and click this button to remove it from the list.
Note: You cannot remove a group with which an AP is associated.
DCS Now Select one or multiple groups and click this button to use DCS (Dynamic Channel
Selection) to allow the APs in the group(s) to automatically find a less-used channel in
an environment where there are many APs and there may be interference.
Note: You should have enabled DCS in the applied AP radio profile berfore the APs can
use DCS.
Note: DCS is not supported on the radio which is working in repeater AP mode.
# This is the index number of the group in the list.
Group Name This is the name of the group.
Member Count This is the total number of APs which belong to this group.
Apply Click Apply to save your changes back to the ZyWALL/USG.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
