Chapter 37 IDP
ZyWALL/USG Series User’s Guide
644
37.2 The IDP Profile Screen
An IDP profile is a set of packet inspection signatures.
Packet inspection signatures examine packet content for malicious data. Packet inspection applies
to OSI (Open System Interconnection) layer-4 to layer-7 contents. You need to subscribe for IDP
service in order to be able to download new signatures.
In general, packet inspection signatures are created for known attacks while anomaly detection
looks for abnormal behavior.
Click Configuration > UTM Profile > IDP > Profile to open this screen. Use this screen to view
registration and signature information.
Note: You must register in order to use packet inspection signatures. See the
Registration screens.
If you try to enable IDP when the IDP service has not yet been registered, a warning screen
displays and IDP is not enabled.
Click on the icons to go to the OneSecurity.com website where there is guidance on configuration
walkthroughs, troubleshooting and other information.
Figure 448 Configuration > UTM Profile > IDP > Profile
The following table describes the fields in this screen.
Table 246 Configuration > UTM Profile > IDP > Profile
LABEL DESCRIPTION
Profile Management
Add Click Add to create a new profile. Select from the options in the box.
Edit Select an entry and click this to be able to modify it.
Remove Select an entry and click this to delete it.
To Next Page
Loading...
