Chapter 29 IPSec VPN
ZyWALL/USG Series User’s Guide
558
Figure 382 Configuration > VPN > IPSec VPN > Concentrator > Add/Edit
Each field is described in the following table.
29.5 ZyWALL/USG IPSec VPN Client Configuration
Provisioning
Use the Configuration > VPN > IPSec VPN > Configuration Provisioning screen to configure
who can retrieve VPN rule settings from the ZyWALL/USG using the ZyWALL/USG IPSec VPN Client.
In the ZyWALL/USG IPSec VPN Client, you just need to enter the IP address of the
ZyWALL/USG to
get all the VPN rule settings automatically. You do not need to manually configure all rule settings in
the ZyWALL/USG IPSec VPN client.
VPN rules for the ZyWALL/USG IPSec VPN Client have certain restrictions. They must not contain
the following settings:
• AH active protocol
• NULL encryption
• SHA512 authentication
Table 213 VPN > IPSec VPN > Concentrator > Add/Edit
LABEL DESCRIPTION
Name Enter the name of the concentrator. You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
Member Select the concentrator’s IPSec VPN connection policies.
Note: You must disable policy enforcement in each member. See Section 29.2.1 on page 541.
IPSec VPN connection policies that do not belong to a VPN concentrator appear under Available.
Select any VPN connection policies that you want to add to the VPN concentrator and click the
right arrow button to add them.
The VPN concentrator’s member VPN connections appear under Member. Select any VPN
connections that you want to remove from the VPN concentrator, and click the left arrow button
to remove them.
OK Click OK to save your changes in the ZyWALL/USG.
Cancel Click Cancel to exit this screen without saving.
To Next Page
Loading...
