Chapter 7 Monitor
ZyWALL/USG Series User’s Guide
208
The following table describes the labels in this screen.
Table 62 Monitor > Wireless > Radio List
LABEL DESCRIPTION
More Information Click this icon to see the traffic statistics, station count, SSID, Security Mode and
VLAN ID information on the AP.
# This field is a sequential value, and it is not associated with a specific radio.
AP Description Enter a description for this AP. You can use up to 31 characters, spaces and
underscores allowed.
Model This field displays the AP’s hardware model information. It displays N/A (not
applicable) only when the AP disconnects from the ZyWALL/USG and the
information is unavailable as a result.
MAC Address This field displays the MAC address of the AP.
Radio This field displays the Radio number. For example 1.
OP Mode This field displays the operating mode of the AP. It displays n/a for the profile
for a radio not using an AP profile.
AP Mode means the AP can receive connections from wireless clients and pass
their data traffic through to the ZyWALL/USG to be managed (or subsequently
passed on to an upstream gateway for managing).
Profile This field displays the AP Profile for the Radio. It displays n/A for the radio profile
not using an AP profile. It displays default if using a default profile.
Frequency Band This field displays the WLAN frequency band using the IEEE 802.11 a/b/g/n
standard of 2.4 or 5 GHz.
Channel ID This field displays the WLAN channels using the IEEE 802.11 protocols.
Station This field displays the station count information.
Rx PKT This field displays the data packets of incoming traffic on the AP.
Tx PKT This field displays the data packet of outgoing traffic on the AP.
Rx FCS Error Count This field displays the erroneous data packet count received and detected by
Frame Check Sequence (FCS)
Tx Retry Count This field displays the data packet count that were transmitted for retry.
To Next Page
Loading...
