Chapter 10 Interfaces
ZyWALL/USG Series User’s Guide
309
Figure 232 Network > Interface > Tunnel > Add/Edit
Each field is explained in the following table.
Table 111 Network > Interface > Tunnel > Add/Edit
LABEL DESCRIPTION
Show Advanced
Settings / Hide
Advanced Settings
Click this button to display a greater or lesser number of configuration fields.
General Settings
Enable Select this to enable this interface. Clear this to disable this interface.
Interface Properties
Interface Name This field is read-only if you are editing an existing tunnel interface. Enter the name of
the tunnel interface. The format is tunnelx, where x is 0 - 3. For example, tunnel0.
Zone Use this field to select the zone to which this interface belongs. This controls what
security settings the ZyWALL/USG applies to this interface.
To Next Page
Loading...
