Chapter 3 Hardware, Interfaces and Zones
ZyWALL/USG Series User’s Guide
59
The following table describes the LEDs.
The following table describes the USG2200-VPN LEDs.
Table 11 LED Descriptions
LED COLOR STATUS DESCRIPTION
PWR Off The ZyWALL/USG is turned off.
Green On The ZyWALL/USG is turned on.
Red On There is a hardware component failure. Shut down the device, wait for a few
minutes and then restart the device. If the LED turns red again, then please
contact your vendor.
SYS Green Off The ZyWALL/USG is not ready or has failed.
On The ZyWALL/USG is ready and running.
Blinking The ZyWALL/USG is booting.
Red On The ZyWALL/USG xd an error or has failed.
USB Green Off No device is connected to the ZyWALL/USG’s USB port or the connected
device is not supported by the ZyWALL/USG.
On A mobile broadband USB card or USB storage device is connected to the USB
port.
Orange On Connected to a mobile broadband network through the connected mobile
broadband USB card.
P1, P2... Green Off There is no traffic on this port.
Blinking The ZyWALL/USG is sending or receiving packets on this port.
Orange Off There is no connection on this port.
On This port has a successful link.
Table 12 USG2200-VPN LED Descriptions
LED COLOR STATUS DESCRIPTION
PWR1, 2 Off The ZyWALL/USG is turned off.
Green On The ZyWALL/USG is turned on.
Red On There is a hardware component failure. Shut down the device, wait for a few
minutes and then restart the device. If the LED turns red again, then please
contact your vendor.
SYS Green Off The ZyWALL/USG is not ready or has failed.
On The ZyWALL/USG is ready and running.
Blinking The ZyWALL/USG is booting.
Red On The ZyWALL/USG xd an error or has failed.
P1-P4
(SFP)
Link
Green Off There is no connection on this port.
On This port has a successful 100Mbps link.
Orange Off There is no connection on this port.
On This port has a successful 1000Mbps link.
P1-P4
(SFP)
ACT
Green Off There is no traffic on this port.
On The ZyWALL/USG is sending or receiving packets on this port.
To Next Page
Loading...
