Chapter 41 Device HA
ZyWALL/USG Series User’s Guide
709
Figure 483 Configuration > Device HA > General
The following table describes the labels in this screen.
Table 274 Configuration > Device HA > General
LABEL DESCRIPTION
Enable Device
HA
Turn the ZyWALL/USG’s Device HA feature on or off.
Note: It is not recommended to use STP (Spanning Tree Protocol) with Device HA.
Device HA Mode This displays whether the ZyWALL/USG is currently set to use active-passive mode Device
HA. Active-passive mode is recommended for general device failover deployments.
Click the link to go to the screen where you can configure the ZyWALL/USG to use the
Device HA pro mode that it is not currently using.
Monitored
Interface
Summary
This table shows the status of the interfaces that you selected for monitoring in the other
Device HA screens.
# This is the entry’s index number in the list.
Interface These are the names of the interfaces that are monitored by Device HA.
Virtual Router IP
/ Netmask
This is the interface’s IP address and subnet mask. Whichever ZyWALL/USG is the master
uses this virtual router IP address and subnet mask.
Management IP /
Netmask
This field displays the interface’s management IP address and subnet mask. You can use
this IP address and subnet mask to access the ZyWALL/USG whether it is in master or
backup mode.
Link Status This tells whether the monitored interface’s connection is down or up.
To Next Page
Loading...
