Chapter 41 Device HA
ZyWALL/USG Series User’s Guide
712
Figure 485 Configuration > Device HA > Device HA Prol
The following table describes the labels in this screen.
Table 275 Configuration > Device HA > Device HA Pro
LABEL DESCRIPTION
Enable Configuration
Provisioning From Active
Device.
Select this to have a passive ZyWALL/USG copy the active ZyWALL/USG’s
configuration, signatures (anti-virus, IDP/application patrol, and system
protect), and certificates.
Note: Only ZyWALL/USGs of the same model and firmware version can
synchronize.
Serial Number of Licensed
Device for License
Synchronization
Type the serial number of the ZyWALL/USG (active or passive) with the Device
HA Pro subscribed license.
Active Device Management
IP
Type the IPv4 address of the highest-numbered port on the active ZyWALL/USG
(the heartbeat dedicated link port).
Passive Device
Management IP
Type the IPv4 address of the highest-numbered port on the passive ZyWALL/
USG (the heartbeat dedicated link port).
Note: The active and passive ZyWALL/USG Management IP addresses must be
in the same subnet.
Subnet Mask Type the subnet mask for the management IP addresses.
To Next Page
Loading...
