Chapter 42 Object
ZyWALL/USG Series User’s Guide
757
Figure 515 Configuration > Object > MON Profile > Add/Edit MON Profile
The following table describes the labels in this screen.
Table 300 Configuration > Object > MON Profile > Add/Edit MON Profile
LABEL DESCRIPTION
Activate Select this to activate this monitor mode profile.
Profile Name This field indicates the name assigned to the monitor mode profile.
Channel dwell time Enter the interval (in milliseconds) before the AP switches to another channel for
monitoring.
Scan Channel Mode Select auto to have the AP switch to the next sequential channel once the Channel
dwell time expires.
Select manual to set specific channels through which to cycle sequentially when the
Channel dwell time expires. Selecting this options makes the Scan Channel List
options available.
Set Scan Channel
List (2.4 GHz)
Move a channel from the Available channels column to the Channels selected
column to have the APs using this profile scan that channel when Scan Channel Mode
is set to manual.
These channels are limited to the 2 GHz range (802.11 b/g/n).
To Next Page
Loading...
